Step-by-step – Realtek Rtl8188CE Kali Driver Installation

September 23, 2020 | By the+gnu+linux+evangelist.

GNU/Linux Kali Installing Realtek RTL8188CE Driver Guide

Hi! The Tutorial shows you Step-by-Step How to Install Realtek RTL8188CE WiFi/Bluetooth Wireless Driver from Source Code in Kali GNU/Linux Desktop.

And this Realtek RTL8188CE Driver in Kali Fixes some well known Issues and so:

  • It has been modified to allow you to transmit at up to 33 dBm instead of the stock driver hard limit of 20 dBm, regardless of your CRDA regulatory domain. This is a substantial increase in capability because every 3 dB increase is equivalent to a doubling of the power. IOW, you can pump out 4x more Tx power than before. This is subject to CRDA restrictions however (though you can set that to whatever you want, just make sure you’re staying legal)
  • It has a few default settings that generally increase stability
  • Some helpful fixes are backported from newer kernels so that they can be enjoyed without upgrading the entire kernel (very useful for staying on your distros current kernel while benefitting from fixes relating to this driver)

Again this Driver may be functioning also for all the following Realtek Chipsets:

  • RTL8188CE/RTL8188EE
  • RTL8191SE
  • RTL8192CE/RTL8192DE/RTL8192SE
  • RTL8723AE

As suggested from the Realtek Driver Support.

Most noteworthy: a Module is already bundled into the Linux Kernel, so in this case if you want to try this quick Solution see first the Realtek Firmware Setup Guide.

Especially relant: please be aware of how this Driver is Not supporting all the Linux Kernels range, so in case of issue consult the available Online Documentation.

Finally, this Realtek RTL8188CE Driver Kali Linux Setup should be working also after a Kernel Upgrade with the Dkms integration.

Step-by-step Realtek RTL8188CE Driver Installation in Kali Linux - Featured
  1. 1. Launching Terminal

    How to QuickStart with Command Line on Kali GNU/Linux

    Bash Shell Kali QuickStart Guide

    First, Update the Apt Repo Sources with:

    sudo apt update
    Authenticate with the User Admin Pass.
    If Got “User is Not in Sudoers file” then see: How to Enable sudo.
  2. 2. Installing Dependencies

    Then to Install Required Stuff
    First, play:

    sudo apt install bc build-essential git module-assistant dkms
    Now better to Upgrade the System with:
    sudo apt upgrade
    And in this case after Restart your System running:
    sudo reboot
    Last, to Setup the Kernel Headers and other eventual Requirements run:
    sudo m-a prepare

QuickChic Theme • Powered by WordPress