Step-by-step – Gqrx SDR Mageia 7 Installation

December 11, 2020 | By the+gnu+linux+evangelist.

GNU/Linux Mageia 7 Installing Gqrx SDR – QuickStart Guide

Hi! The Tutorial shows you Step-by-Step How to Install Gqrx SDR Receiver Software in Mageia 7.x/8.x/Cauldron GNU/Linux Desktop.

And Gqrx SDR for Mageia is an Open Source Software Defined Radio Receiver (SDR) powered by the GNU Radio and the Qt UI.

Currently, it works on Linux and Mac with Hardware supported by gr-osmosdr, including Funcube Dongle, RTL-SDR, Airspy, HackRF, BladeRF, RFSpace, USRP and SoapySDR.

The Gqrx Features at a glance are:

  • Discover devices attached to the computer
  • Process I/Q data from the supported devices
  • Change frequency, gain and apply various corrections (frequency, I/Q balance)
  • AM, SSB, CW, FM-N and FM-W (mono and stereo) demodulators
  • Special FM mode for NOAA APT
  • Variable band pass filter
  • AGC, squelch and noise blankers
  • FFT plot and waterfall
  • Record and playback audio to / from WAV file
  • Record and playback raw baseband data
  • Spectrum analyzer mode where all signal processing is disabled
  • Basic remote control through TCP connection
  • Streaming audio output over UDP

Finally, this guide includes detailed instructions about to Getting-Started with Gqrx SDR on Mageia.

Step-by-step Gqrx SDR Mageia 7 Installation Guide - Featured
  1. 1. Terminal QuickStart

    How to QuickStart with Command Line on Mageia

    Bash Shell Mageia QuickStart Guide

    First, Update the Apt Repo Sources with:

    sudo apt update
    Authenticate with the User Admin Pass.
    If Got “User is Not in Sudoers file” then see: How to Enable sudo.

QuickChic Theme • Powered by WordPress