GNU/Linux Fedora Rawhide Install Slic3r – QuickStart Guide
Hi! The Tutorial shows you Step-by-Step How to Download and Install Slic3r 3D Printing Software in Fedora Rawhide 64-bit GNU/Linux Desktop.
And Slic3r for Fedora is the Open-Source Tool you need to Convert a 3D Model (STL, OBJ, AMF) into Printing Instructions for your 3D Printer.
It Cuts the Model into Horizontal Slices (Layers), Generates Toolpaths to Fill them and Calculates the Amount of Material to be Extruded.
Especially relevant how it’s Compatible with Any Modern Printer based on the RepRap Toolchain, including all those based on the Marlin, Sprinter and Repetier Firmware.
Moreover, it also Works with Mach3, LinuxCNC and Machinekit Controllers.
Finally, this guide includes detailed instructions about to Getting-Started with Slic3r on Fedora.
![Step-by-step Slic3r Fedora Rawhide Installation Guide - Featured](https://tutorialforlinux.com/wp-content/media/dg139/intro/gnomePenguin3D.jpg)
1. Launching Shell Emulator
Open a Terminal window
(Press “Enter” to Execute Commands).2. Installing AppImageLauncher
Then to Set up AppImageLauncher on Fedora
AppImageLauncher Fedora Setup GuideThe AppImage may Not Verified so to Run it Securely in a Sandbox see: Firejail Setup.
Contents