Step by step – How to Install Slic3r on MX Linux 19

GNU/Linux MX 19 Install Slic3r – Step by step Guide

How to Download and Install Slic3r 3D Printing Software on MX 19.x 64-bit GNU/Linux desktop – Step by step Tutorial.

And Slic3r for MX Linux is the Open-Source Tool you need to Convert a 3D Model (STL, OBJ, AMF) into Printing Instructions for your 3D Printer.

It Cuts the Model into Horizontal Slices (Layers), Generates Toolpaths to Fill them and Calculates the Amount of Material to be Extruded.

Especially relevant how it’s Compatible with Any Modern Printer based on the RepRap Toolchain, including all those based on the Marlin, Sprinter and Repetier Firmware.

Moreover, it also Works with Mach3, LinuxCNC and Machinekit Controllers.

Finally, this guide includes detailed instructions on Getting Started with Slic3r on MX Linux.

1. 1. Launching Shell Emulator

   Open a Terminal window
   (Press “Enter” to Execute Commands).

   

2. 2. Installing AppImageLauncher

   (Optional) Then to Set up AppImageLauncher on MX Linux
   

   AppImageLauncher MX Linux Setup Guide

   The AppImage may Not Verified so to Run it Securely in a Sandbox see: Firejail Setup.

   How to Install AppImageLauncher on MX GNU/Linux
   Optional because you can simply Download and Run the AppImage As Is.