$schemamarkup = get_post_meta(get_the_ID(), 'schemamarkup', true); if(!empty($schemamarkup)) { echo $schemamarkup; }

Step-by-step – How to Install Slic3r on Zorin OS

March 5, 2020 | By the+gnu+linux+evangelist.

GNU/Linux Zorin OS Install Slic3r – QuickStart Guide

Hi! The Tutorial shows you Step-by-Step How to Download and Install Slic3r 3D Printing Software in Zorin OS 9.x/12.x/15.x 64-bit GNU/Linux Desktop.

And Slic3r for Zorin OS is the Open-Source Tool you need to Convert a 3D Model (STL, OBJ, AMF) into Printing Instructions for your 3D Printer.

It Cuts the Model into Horizontal Slices (Layers), Generates Toolpaths to Fill them and Calculates the Amount of Material to be Extruded.

Especially relevant how it’s Compatible with Any Modern Printer based on the RepRap Toolchain, including all those based on the Marlin, Sprinter and Repetier Firmware.

Moreover, it also Works with Mach3, LinuxCNC and Machinekit Controllers.

Finally, this guide includes detailed instructions about to Getting-Started with Slic3r on Zorin OS.

Step-by-step Slic3r Zorin OS Installation Guide - Featured
  1. 1. Launching Shell Emulator

    Open a Terminal window
    (Press “Enter” to Execute Commands).

    Step-by-step Slic3r Zorin OS Installation Guide - Open Terminal Shell Emulator
    Ctrl+Alt+t on Desktop.
  2. 2. Installing AppImageLauncher

    Then to Set up AppImageLauncher on Zorin OS

    AppImageLauncher Zorin OS Setup Guide
    The AppImage may Not Verified so to Run it Securely in a Sandbox see: Firejail Setup.
    Optional because you can simply Download and Run the AppImage As Is.