Installing
-
2. Pre-Installation Checks
Then Check if KVM Can be Installed
With:egrep -c '(vmx|svm)' /proc/cpuinfo
If in Output > 0 then your Processor support Hardware Virtualization!
(But on a PC you may have still to enable it on BIOS…)
Now again, first Install needed Tool with:sudo apt install cpu-checker
And then Verify it:
kvm-ok
If it’s Good you will see:
INFO: /dev/kvm exists KVM acceleration can be used
Finally, if the answer is negative you can still use KVM but only in a Slow mode…
-
3. Installing KVM
Now you are Ready to Install KVM on Mint System
Now KVM should already be there, to Check for it try to load the Kernel Module:modprobe kvm
Again on Intel Processors:
modprobe kvm_intel
But for AMD instead:
modprobe kvm_amd
Last, to Add the default Virtualization Frontend managing Stack run:
sudo apt install qemu qemu-system qemu-kvm libvirt-bin ubuntu-vm-builder bridge-utils
Following Mint Documentation about KVM related Packages:
- libvirt-bin provides libvirtd which you need to administer qemu and kvm instances using libvirt
- qemu & qemu-kvm (kvm in Karmic and earlier) are the backend
- ubuntu-vm-builder powerful command line tool for building virtual machines
- bridge-utils provides a bridge from your network to the virtual machines
Contents