Step-by-step – Gqrx SDR CentOS 7 Installation

December 11, 2020 | By the+gnu+linux+evangelist.

GNU/Linux CentOS 7 Installing Gqrx SDR – QuickStart Guide

Hi! The Tutorial shows you Step-by-Step How to Install Gqrx SDR in CentOS 7.6+ GNU/Linux Desktop.

And Gqrx SDR for CentOS is an Open Source Software Defined Radio Receiver (SDR) powered by the GNU Radio and the Qt UI.

Currently, it works on Linux and Mac with Hardware supported by gr-osmosdr, including Funcube Dongle, RTL-SDR, Airspy, HackRF, BladeRF, RFSpace, USRP and SoapySDR.

The Gqrx Features at a glance are:

  • Discover devices attached to the computer
  • Process I/Q data from the supported devices
  • Change frequency, gain and apply various corrections (frequency, I/Q balance)
  • AM, SSB, CW, FM-N and FM-W (mono and stereo) demodulators
  • Special FM mode for NOAA APT
  • Variable band pass filter
  • AGC, squelch and noise blankers
  • FFT plot and waterfall
  • Record and playback audio to / from WAV file
  • Record and playback raw baseband data
  • Spectrum analyzer mode where all signal processing is disabled
  • Basic remote control through TCP connection
  • Streaming audio output over UDP

Moreover, this guide includes detailed instructions about to Getting-Started with Gqrx SDR on CentOS.

Finally, this Setup is Valid also for All the others Red Hat Linux Based Distros like:

  • Red Hat Enterprise Linux
  • Oracle Enterprise Linux
  • Rocky Linux
  • AlmaLinux
Featured
  1. 1. Terminal QuickStart

    How to QuickStart with Command Line on CentOS

    Bash Shell CentOS QuickStart Guide


QuickChic Theme • Powered by WordPress