Step-by-step – Ultimaker Cura Fedora 34 Installation Guide

March 19, 2021 | By the+gnu+linux+evangelist | Filed in: Tutorial.

GNU/Linux Fedora 34 Installing Ultimaker Cura – Quick Start Guide

You are Welcome! The Tutorial Shows You Step-by-Step How to Install Ultimaker Cura in Fedora 34 64-bit GNU/Linux Desktop.

And Ultimaker Cura for Fedora 34 prepares your Model for 3D Printing. Optimized, Expert-Tested Profiles for 3D Printers and Materials mean you can Start Printing Reliably in No Time.

Especially relevant: Cura is made available for Fedora 34 by a Portable AppImage that you can just Get and Run from Anywhere.

Finally, this guide includes instructions on How to Getting-Started with Cura on Fedora Systems.

Step-by-step – Ultimaker Cura Fedora 34 Installation Guide
  1. 1. Launching Shell Emulator

    Open a Terminal window
    (Press “Enter” to Execute Commands)

    How to Install Cura on Fedora 34 - Open Terminal Shell Emulator
  2. 2. Installing AppImageLauncher

    How to Install AppImageLauncher in Fedora

    AppImageLauncher Fedora Setup Guide

    The Setup grant the AppImages integration but is Not Required because you can simply Grab and Run the AppImage as is.


Tags: , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , ,

QuickChic Theme • Powered by WordPress