Step-by-step – Ultimaker Cura Gentoo GNU/Linux Installation Guide

September 25, 2021 | By the+gnu+linux+evangelist | Filed in: Tutorial.

GNU/Linux Gentoo Installing Ultimaker Cura – Quick-Start Guide

Hi! The Tutorial Shows You Step-by-Step How to Ultimaker Cura in Gentoo GNU/Linux 64-bit Desktop.

And Ultimaker Cura for Gentoo Linux prepares your Model for 3D Printing. Optimized, Expert-Tested Profiles for 3D Printers and Materials mean you can Start Printing Reliably in No Time.

So this Guide is Valid for All the others Gentoo Linux Based Distros like:

  • Funtoo
  • Sabayon

Finally, this guide includes instructions on How to Getting-Started with Cura on Gentoo Systems.

Auto Draft
  1. 1. Launching Shell Emulator

    Open a Shell Terminal emulator window
    Dirtectly start Typing ‘konsole’ on Desktop.
    (Press “Enter” to Execute Commands)

     - open terminal
  2. 2. Installing AppImageLauncher

    How to Install AppImageLauncher in Gentoo

    AppImageLauncher Gentoo Setup Guide
    The Setup grant the AppImages integration but is Not Required because you can simply Grab and Run the AppImage as is.

Tags: , , , , , , , , , , , , , , , , , , , ,

QuickChic Theme • Powered by WordPress